Wear damage is hardly to be avoided in our life,especially in bulk material handling industry. like mining,cement,port,power generation plants,chemical industry etc.rubber, ceramics, steel are nomally applied for wear protection solution, but ceramic abrasion resistant lining is best choosen for its high hardness,ligh weight,high temperature resistance.

Chemshun Ceramics offer Al2O3 92% ,95% abrasion resistant linings ,like ceramic pipe lining, wear ceramic tile liner, alumina plain tile, hex tile mats,rubber wear ceramic liner , ceramic rubber hose etc. ceramic linings installation is very important. 

1.In the rainy season or when the ambient humidity is large, the metal material should be coated with glue immediately after the surface of the metal rust cleaned

2. Glue should be strictly in accordance with the proportion of the proportion of accurate matching, and arrangements for the preparation of special staff to reduce the proportion of glue caused by the construction quality problems.

3. Glue will be completely cured after two-hours mixed, s  glue should be used within 40 minutes.

4. Low temperature seriously affect the adhesive strength of glue, especially when the temperature is lower than 0 ℃, the glue will freeze, completely lost the ability to bond, ceramic abrasion resistant lining can not be normal sticky. In this case, the surface to be bonded can be heated to 30 centi-degree (no more than 50 centi-degree) before the bonding operation is carried out until the curing is completed.

Scan and Share