Except ceramic tile liner,  rubber ceramic wear liner ,ceramic elbow pipe liner,hex tile mat,alumina grinding balls etc, Chemshun Ceramics also provide ceramic epoxy resin adhesive for wear resistant ceramic installation. detailed ceramic epoxy adhesive application process as follows :

1. will be sticky surface grinding rust; if oil, the application of 99% acetone cleaning: If the bonding surface is non-metallic, the surface should be polished, coarsening. This step is for bonding firmly. 

2. Mix the glue evenly, press A: B = 4: 1 (weight ratio) mix, mix thoroughly, apply to the surface of the object to be bonded, in the wear-resistant ceramic adhesive surface is also coated with glue, as required bonding and rubber Hammer hit, so that bonding firm, hardening at room temperature 2h.

3. Room temperature curing 8h, the rubber hammer can be used to check the sound to determine whether the phenomenon of lack of plastic, if the phenomenon of lack of plastic, wear-resistant ceramic should be up, local re-bonding. 

End users need pay attention to some problems when use ceramic epoxy adhesive, details like following items: 

1. In the rainy season or the construction site is moderately large, if the bonding surface for the metal material, should be polished immediately after grinding to prevent metal rust.

2. glue should be A: B = 4: 1 (weight ratio) accurate ratio, it is recommended to arrange the preparation of glue, in order to avoid the proportion of glue is not accurate and the construction quality problems. 

3. glue configured, it will soon cure, should be used within 40min, with the use of configuration. 

4. When the construction site temperature is below 10 ℃, the adhesive strength of the glue will change, especially when the temperature is lower than 0 ℃, the glue will freeze, it seems to have cured, but in fact no bonding strength, the user in use There will be a drop phenomenon. Therefore, under low temperature conditions, should be heated curing (iodine tungsten lamp heating), the surface to be bonded to about 30 ℃ (not more than 50 ℃), adhesive bonding, heating until curing. Noting the above problems, after construction and construction, there will not be a wide range of problems, the side to improve the production efficiency.

 Rubber ceramic wear liner is hot seller products because of its high impact and abrasion resistance. it can be installed by ceramic epoxy resin diretly . more information needed ,welcome to inquiry  by office@chemshun.com